A 6-pin header mapped to the SPI pins (D11, D12, D13) and a Chip Select (CS) pin for data logging.
int readUltrasonic() digitalWrite(trigPin, LOW); delayMicroseconds(2); digitalWrite(trigPin, HIGH); delayMicroseconds(10); digitalWrite(trigPin, LOW); long duration = pulseIn(echoPin, HIGH); int distance = duration * 0.034 / 2; return distance; arduino sensor shield v5 0 manual
Related search suggestions (you can use these terms to find more info) A 6-pin header mapped to the SPI pins
This manual provides everything you need to know about the Sensor Shield V5.0, including its layout, power management, and step-by-step wiring instructions. 📌 Technical Specifications : Arduino Uno R3, Duemilanove, Leonardo Ensure the shield is pressed completely flat against
Loose connections, missing pull-up resistors, or improper wiring to the dedicated I2C header.
Ensure the shield is pressed completely flat against the Arduino board. Check that the Arduino itself is receiving power via USB or the DC barrel jack.
Its primary purpose is to simplify the connection of multiple sensors, actuators (such as servos), and communication modules. Instead of fumbling with a separate breadboard to provide power and ground connections for each component, the Sensor Shield V5.0 provides a for every single I/O pin on your Arduino.