Motorola Gm950 Programming Software Install

Open Windows and check under Ports (COM & LPT) to find the assigned number (e.g., COM3). Open the DOSBox configuration file ( dosbox.conf ). Scroll down to the [serial] section.

Unless you have a 25-year-old laptop, the best way to run this software is via .

Test Communication

Installing the CPS. Ok, let's get the last part done. If you downloaded the Motorola RSS you will find two folders in the archive. Programming the Motorola GM950 on Windows 10

(not recommended – serial timing is poor). motorola gm950 programming software install

Type dir to see the file list, and find the executable file (usually gm950.exe or run.bat ). Run the executable (e.g., gm950.exe ). 3. Configuring Serial Ports in DOSBox

The Ultimate Guide to Motorola GM950 Programming Software Installation (2026 Edition) Open Windows and check under Ports (COM &

The Motorola GM950 is a robust mobile transceiver widely used in commercial and amateur radio settings. While the hardware is built like a tank, programming it on modern systems can be a challenge due to its legacy software requirements.

To successfully install and use the programming software, you will need the following components: Unless you have a 25-year-old laptop, the best

You need a GM950-compatible programming cable. This typically features an RJ-45 connector on one end (to plug into the radio's microphone jack) and a DB9 Serial (RS-232) connector or USB connector on the other.

Open Windows and expand the Ports (COM & LPT) section.