Sinotimer | Tm630s Manual
Program button (enters and cycles through program settings). D+: Sets the day of the week. H+: Sets the hour. M+: Sets the minute. S+: Sets the second.
Press and M+ (and optionally S+ ) to set the exact time you want the connected device to turn ON.
The TM630S features four terminals, usually clearly labeled on the casing. sinotimer tm630s manual
Enters the programming mode and cycles through the 16 ON/OFF settings. D+ (Day): Sets the day of the week. H+ (Hour): Sets the current hour or program hour. M+ (Minute): Sets the current minute or program minute.
The TM630S features a straightforward terminal block at the top and bottom. Always turn off the main power supply before attempting any wiring. Terminal Definitions Program button (enters and cycles through program settings)
Countdown mode is ideal for running an appliance (like a pump or heater) for a specific duration before it automatically turns off.
Hold down the CLOCK button and press the S+ button to sync seconds if exact precision is required. How to Program On/Off Timers M+: Sets the minute
Ensure the input voltage matches the rating printed on the side of your TM630S housing. Step-by-Step Programming Guide
Press the (Cancel/Recall) button. The time display will change to dashes ( --:-- ), indicating the program is cleared. Utilizing the MANUAL Button Modes
The TM630S supports up to 28 independent timing blocks. You can assign programs to Channel 1, Channel 2, or both. Step-by-Step Programming:
