V2000-c Rfid Access Control User Manual !!hot!! Site

For an : Connect the V2000-C NO (Green) wire to the lock positive terminal. Connect the lock negative terminal to the power supply GND. Connect the V2000-C COM (White) wire to the power supply +12V. Programming Guide

Press and hold the # key or the while restoring power to the unit. Release the button after hearing two short beeps.

Electric Lock, Exit Button, External Alarm, Wiegand Reader Package Contents 1 × V2000-C Access Control Keypad 1 × Installation Kit (Screws and Wall Plugs) 1 × Diode (For protecting the relay circuit from spikes) 1 × User Manual / Quick Reference Guide 2. Installation and Wiring Diagram

The V2000-C is a standalone RFID (Radio Frequency Identification) access control system designed to manage entry to restricted areas (doors, gates, or turnstiles). This report consolidates the critical sections of its user manual, focusing on safety, installation, programming, and troubleshooting.

Security settings should be handled by an authorized technician. Always test the Exit Button and emergency overrides after installation.

Requires X cards (1-9) to be swiped in sequence to open the door.

Press 0000 + # . (Note: This clears all cards and PINs but retains the master code). Setting the Door Release Interlocking Time

involves proper physical mounting and exact wiring connection to an external power supply unit (PSU) and electric locking hardware. Mounting Instructions

Check your relay wiring. Ensure Fail-Safe locks use the NC wire and Fail-Secure locks use the NO wire.